Qlogic 3200 Series User Manual - -Dc
7–iSCSI Noninteractive Commands
-d (Drivers Update)
SN0054667-00 G
7-7
-d
(Drivers Update)
To install an adapter driver for all iSCSI adapters on the system from a .zip
or .inf file, issue the -d command as follows:
-d <file_name>
A system reboot may be required; see the log file for details.
-dc
(Display Destination Cache [IPv6])
The IPv6 destination cache contains the IP address, next-hop IP address, and
path MTU information for both local and remote destinations. For multicast and
on-link unicast destinations, the next-hop IP address always matches the
destination IP address. For unicast destinations that are off-link, the next-hop IP
address is the IP address of the router.
To display the destination cache, issue the -dc command as follows:
-dc <hba_port_inst>
-dce
(Display Connection Error Log)
To display the connection error logs for up to 100 of the last connections, issue the
-dce command as follows:
-dce <hba_port_inst> <target_ID> <filename>
If <hba_port_inst> and <target_ID> are not specified, all entries for all
adapter ports are displayed. If <filename> is specified, then the log is written to
that file.
-defbidi
(Add a Default BIDI CHAP)
To add a default BIDI CHAP entry to the specified hba_port_inst, issue the
-defbidi command as follows:
-defbidi <hba_port_inst> <chap_secret>
Where <chap_secret> is the CHAP secret.
The adapter is reset after this command is issued.
-delchap
(Delete a CHAP Entry)
To delete the specified CHAP entry, issue the -delchap command as follows:
-delchap <hba_port_inst> <CHAP>
Issuing this command resets the adapter.