Qlogic 3200 Series User Manual - -Ipdhcp
7–iSCSI Noninteractive Commands
-ipdhcp (Configure IP Settings)
7-14
SN0054667-00 G
-ipdhcp
(Configure IP Settings)
To set the adapter to get its IP address, subnet mask, and gateway from the
DHCP server, issue the -ipdhcp command as follows:
-ipdhcp <hba_port_inst> [-option]
If the adapter port had prior values set manually, the DHCP values replace them.
Where [option]includes:
-l
(List LUN Information)
Use the -l command to view the following information about LUNs attached to
the selected target:
Adapter, target, or LUN number
Vendor name
Product ID
Product revision
LUN size
F = Configure the firmware.
N = Configure the network parameters.
I = Configure the iSCSI name.
T = Configure the targets.
C = Configure the CHAP table.
B = Configure the boot parameters (only valid when the
T [targets] parameter is also specified).
file_name = The XML file with the adapter configuration. See
“-save (Save Host Configuration)” on page 7-24
).
-DISN4 = Disable IPv4 network
-IPV4DHCP = Set DHCP ON
-IP = Set IP Address
-IPNM = Set IP Netmask
-IPGW = Set IP Gateway
-DISN6 = Disable IPv6 network setup
-IPLLA = Set local link address automatically
-IPLL = Set local link address manually
-IPRA = Set IPR0 and IPR1 automatically
-IPR0 = Set routable address 0 manually
-IPR1 = Set routable address 1 manually
-IPRAA = Set router address automatically
-IPRR = Set router address manually