Qlogic 3200 Series User Manual - page 260
11–Converged Network Adapter Interactive Commands
CNA FCoE Configuration
11-26
SN0054667-00 G
4: Hard Loop ID
5: Loop Reset Delay (seconds)
6: Enable BIOS
7: Enable HBA Hard Loop ID
8: Enable Fibre Channel Tape Support
9: Operation Mode
10: Interrupt Delay Timer (100ms)
11: Execution Throttle
12: Login Retry Count
13: Port Down Retry Count
14: Enable LIP Full Login
15: Link Down Timeout (seconds)
16: Enable Target Reset
17: LUNs per Target
18: Enable Receive Out Of Order Frame
19: Commit Changes
20: Abort Changes
Restore Defaults
2. Adapter Configuration1. CNA Configuration1. CNA FCoE Configuration3. HBA Parameters
3. Restore Defaults
From the HBA Parameters menu, select the Restore Defaults to restore adapter
parameters to their factory default values.
For example:
Warning:
Please update the HBA parameters with extreme care.
Incorrectly updating the HBA parameters may render the HBA inoperable.
NOTE
Execution Throttle does not apply to 2600 and 8300 Series Adapters and is
read-only for 10GbE adapters.
CAUTION
Restoring the adapter parameters can make the adapter inoperable.
When restoring NVRAM parameters, the current BIOS device settings
are also cleared.