Qlogic 3200 Series User Manual - page 117
6–Fibre Channel Noninteractive Commands
-p (Target Persistent Bindings)
SN0054667-00 G
6-31
The following example is a typical QConvergeConsole CLI output showing all
targets currently bound to an adapter:
--------------------------------------------------------------------------
HBA 0: QLA2462 Port 1 WWPN xx-xx-xx-xx-xx-xx-xx-xx Port ID 11-06-EF
--------------------------------------------------------------------------
Bind
Type
Device Node Name
Device Port Name
Port ID
ID
----
----
----------------
----------------
-------
--
No
Disk
xx-xx-xx-xx-xx-xx-xx-xx
xx-xx-xx-xx-xx-xx-xx-xx
10-02-E1
Yes
Disk
xx-xx-xx-xx-xx-xx-xx-xx
xx-xx-xx-xx-xx-xx-xx-xx
10-02-E2
0
Yes
Disk
xx-xx-xx-xx-xx-xx-xx-xx
xx-xx-xx-xx-xx-xx-xx-xx
10-02-E4
1
Yes
Disk
xx-xx-xx-xx-xx-xx-xx-xx
xx-xx-xx-xx-xx-xx-xx-xx
10-02-E8
2
Press
To bind a selected target to a specific adapter, issue the following command:
# qaucli -pr fc -p (<hba instance> | <hba wwpn>) (<target wwnn>
<target wwpn> <target port id> <target id>)
Where:
To bind multiple targets with a single command, repeat the following group:
<target wwnn> <target wwpn> <target port id> <target id>
To bind all targets on a specific adapter or to bind all targets on all adapters, issue
the following command:
# qaucli -pr fc -p (<hba instance> | <hba wwpn> | all) bind all
Where:
To unbind a specific target, issue the following command:
# qaucli -pr fc -p (<hba instance> | <hba wwpn>) (remove <target
wwnn> | unbind <target wwnn>)
hba instance = Adapter number (use the -g command to find)
hba wwnn = Word wide node name of the adapter
hba wwpn = World wide port name of the adapter
target wwnn = World wide node name of the target
target wwpn = World wide port name of the target
target port id = Port ID of the target
target id = ID to which the target is bound
hba instance = Adapter number (use the -g command to find)
hba wwpn = World wide port name of the adapter