Qlogic 3200 Series User Manual - -Ei
7–iSCSI Noninteractive Commands
-ei
SN0054667-00 G
7-11
You can repeat the <Parameter>|<Parameter Alias> <Value> parameter
pair to change multiple values as shown in
. Press ENTER after each entry.
-ei
To get information about errors and exit codes for noninteractive mode, issue the
-ei command as follows (no parameters are required):
-ei
-f
The firmware runs the tasks involved in data management, the iSCSI protocol,
and general adapter functioning. Use the -f command to update the firmware
image.
To update the adapter firmware from a specified file, issue the -f command as
follows:
-f <hba_port_inst> <file name> [reset | noreset]
Both parameters are required. The <hba_port_inst
>
is the adapter to update.
The <file name> is the file containing the firmware image to upload to the
adapter. Be sure to use full path names. Use reset|noreset to specify if there is
a reset after the firmware update.
-g
To view general system information, issue the -g command as follows:
-g
QConvergeConsole CLI shows the following:
Host name
Host version
Host type
User type
Table 7-2. CHAP Parameters
Parameter
Parameter Alias
Value
CHAPName
CNAME
character string
CHAPSecret
CSECRET
character string
CHAPBidi
CBIDI
on or off