Qlogic 3200 Series User Manual - -Statport
7–iSCSI Noninteractive Commands
-statport (Display iSCSI Port Statistics)
SN0054667-00 G
7-25
-statport
(Display iSCSI Port Statistics)
To view the port statistics for the specified adapter, issue the -statport
command as follows:
-statport <hba_port_inst>
-stathba
To display adapter-level statistics, issue the -stathba command as follows:
-stathba <hba_port_inst>
-stdsp
(Display Send Targets)
To view the send targets, issue the -stdsp command as follows:
-stdsp <hba_port_inst>
To use the -stdsp command, you must first issue the -stadd command at
least once to add a send target for discovery only. For more information, see
“-stadd (Add a Send Target)” on page 7-24
.
NOTE
To use the -stdsp, -strd, and -strem commands, you must first issue
the -stadd command at least once to add a send target for discovery only
(no target login). After using the -stadd command to add at least one
send target for discovery only, you can use the -stdsp command to
display all send targets for discovery, along with the appropriate index to be
used for the -strd and -strem commands. The -strd command
(with the target instance from the -stdsp command) must be used to
perform the send target discovery to discover all target portals.
After a send target for discovery only has been added by means of the
-stadd command and discovered by the -strd command, or the iSNS
has been configured (with a valid iSNS server), a list of targets and target
portals is discovered. When you issue the -dtdsp command, the
discovered target portals are displayed. The displayed discovered target
portals are not logged into targets at this time, but are local to
QConvergeConsole CLI and are available for login.
To log a discovered target portal into a target, issue the -dtli
command.
To log all discovered target portals into targets, issue the -dtlia
command.
To remove discovered target portals from the list, issue the -dtrem
command.