Qlogic 3200 Series User Manual - -If
8–NIC Partitioning (NPAR) Noninteractive Commands
-if
SN0054667-00 G
8-5
-if
To view a list of NPAR physical functions, issue the -if command as follows:
> qaucli -npar -if
-ip
To view a list of the NPAR physical ports, issue the -ip command as follows:
> qaucli -npar -ip
-peswitchcfg
To change eSwitch physical port configuration, issue the -peswitchcfg
command as follows:
> qaucli -npar -peswitchcfg <port_inst> <option> <value>>
lists the available
-pinfo
(NPAR Port Information)
To view NPAR port information, issue the -pinfo command as follows:
> qaucli -npar -pinfo
Where:
<port_inst> is the physical port number displayed by the -ip
command.
<func_inst> is the physical function number displayed by the -if
command.
-restoreeswitchcfg
(Restore eSwitch Configuration)
To restore eSwitch configuration, issue the -restoreeswitchcfg command
as follows:
> qaucli -npar -restoreeswitchcfg
Table 8-2. eSwitch Physical Port Options
Option
Value
ipv4_tso
Enable (1) or disable (0) IPv4 TSO configuration
ipv6_tso
Enable (1) or disable (0) IPv6 TSO configuration
layer4_co
Enable (1) or disable (0) Layer 4 checksum offload configuration