Qlogic 3200 Series User Manual - -X2
6–Fibre Channel Noninteractive Commands
-x
6-40
SN0054667-00 G
To list a specific virtual port on a physical adapter port, issue the following command:
# qaucli -pr fc -vp (<hba instance> : <hba wwpn>) list
To create a virtual port with an automatic WWPN, issue the following command:
# qaucli -pr fc -vp (<hba instance> : <hba wwpn>) create auto
To create a virtual port with a specific WWPN, issue the following command:
# qaucli -pr fc -vp (<hba instance> : <hba wwpn>) create
When prompted, type two hexadecimal digits. The system checks these digits to
be sure they are unique and, if they are, puts them into byte 1 of the WWPN.
To delete all virtual ports on a physical adapter port, issue the following command:
# qaucli -pr fc -vp (<hba instance> : <hba wwpn>) delete all
To delete a specific virtual port on a physical adapter port, issue this command:
# qaucli -pr fc -vp (<hba instance> : <hba wwpn>) delete <vport wwpn>
-x
You can use the -x option with all noninteractive mode options that have a
corresponding interactive mode option (see
). This option
must be the first or last command in the command line.
When you use this option, the system shows all result and status messages in
XML format 1, a legacy format. This option is usually combined with the -o
option (see
) to create a text file with XML output so that it can be
parsed by an XML-compliant utility. For example to show adapter general
information and output it to an XML file named output.xml:
# qaucli -pr fc -i all -x -o output.xml
-x2
You can use the -x2 option with all noninteractive mode options that have a
corresponding interactive mode option (see
). This option must be the
first or last command in the command line.
NOTE
The -x option is valid only in noninteractive mode.
NOTE
The -x2 option is valid only in noninteractive mode.