Qlogic 3200 Series User Manual - -Dm
6–Fibre Channel Noninteractive Commands
-dm (Transceiver Diagnostics Monitoring Interface [DMI])
6-10
SN0054667-00 G
-dm
(Transceiver Diagnostics Monitoring Interface [DMI])
The -dm option allows you to show general or detailed digital diagnostic
monitoring interface for optical transceivers.
To show transceiver monitoring general information, issue the following command:
# qaucli -pr fc -dm (<hba instance> | <hba wwpn> |
gen
To show transceiver monitoring detailed information, issue the following
command:
# qaucli -pr fc -dm (<hba instance> | <hba wwpn> | all) details |
det
Where:
-e
(Boot Devices Configuration)
Use the -e command to:
Show the current boot device selection for all adapters.
Show the current boot device selection for a specific adapter.
Set a target device as the boot device for an adapter.
Selectable boot; the OS boots from the first target the BIOS finds.
Delete the boot device from an adapter.
In these commands:
NOTE
This option is supported only for QLogic QLA/QLE/QEM24xx (4Gb)
Adapters. Under Solaris, this option is disabled if you are using Linux inbox
drivers (SLES 10.0 or RHEL 5.0 or later).
hba instance = Adapter number (use the -g command to find)
hba wwpn = World wide port name of the adapter
all = All adapters in the system
hba instance = Adapter number (use the -g command to find)
hba wwpn = World wide port name of the adapter
target wwnn = World wide node name of the target
target wwpn = World wide port name of the target
target id = ID to which the target is bound
lun id = ID of the LUN