Qlogic 3200 Series User Manual - -Testflash
5–NIC Noninteractive Commands
-testflash
5-18
SN0054667-00 G
IPv6 Addresses: fe80::2c0:ddff:fe12:ff4
2. CNA: 1 CNA Port: 2 CNA Model: QLE8142 PortID: 1
Mac Phys. Address: 00:c0:dd:12:0f:f6 Loc. Mac: 00:c0:dd:12:0f:f6
CNA Serial Number: AFC0916A07152 MPI FW Version: 1.35.02 Adapter Alias: None
Port Alias: None
IPv4 Address: 192.168.205.200
IPv6 Addresses: fe80::2c0:ddff:fe12:ff6
-testflash
To test the Flash memory, issue the -testflash command as follows:
> qaucli -pr nic -testflash [cna_port_inst]
-testhw
(Hardware Test)
To test the hardware, issue the -testhw command as follows:
> qaucli -pr nic -testhw [cna_port_inst]
-testinterrupt
(Interrupt Test)
To test the interrupt, issue the -testinterrupt command as follows:
> qaucli -pr nic -testinterrupt [cna_port_inst]
-testled
(Beacon/LED Test)
To test the LED, issue the -testled command as follows:
> qaucli -pr nic -testled [cna_port_inst]
NOTE
To stop an active diagnostic test, press ENTER. To use an alternate key to
stop tests, modify this line in the sfcli.properties configuration file:
Default:
node.app.diag.ascii.abortkey=CR
Custom: node.app.diag.ascii.abortkey=<stop key>
Where <stop key> is any alphabetic character a–z or A–Z (uppercase
characters require pressing SHIFT+
Example 1: To set the stop key to S (press SHIFT+S to stop the test):
node.app.diag.ascii.abortkey=S
Example 2: To set the stop key to s (press S to stop the test):
node.app.diag.ascii.abortkey=s