Qlogic 3200 Series User Manual - -Ei
6–Fibre Channel Noninteractive Commands
-ei
SN0054667-00 G
6-13
-ei
Issue the -ei command to view a list of the Fibre Channel error codes.
-f
To input parameter options to QConvergeConsole CLI through a text file, type -f,
followed by the file name. For example:
# qaucli -pr fc -f command.txt
The text file must be formatted as follows:
The file must contain a single line.
The file must contain only parameters.
The file cannot contain another -f option.
The following example shows how to set the connection option of an adapter to
default (loop preferred, otherwise point-to-point) and the data rate to auto through
a command file that is invoked by the -f option:
1.
Create a text file (for example, setadapter0.txt) and issue the following
command in the text file:
-n 0 co 2 dr 2
2.
Save and close the file.
3.
Issue the qaucli -pr fc command with the -f option (input from
command file):
# qaucli -pr fc -f setadapter0.txt
# qaucli -pr fc -f <file name>
QConvergeConsole CLI specifies command line input from the file.
-fg
NOTE
The -f option is valid only in noninteractive mode, and cannot be
combined with any other options. Only one command line parameter per file
is valid. This option is used when it is run as a script file.
NOTE
The -fg option is valid only in noninteractive mode.
The -fg option is not supported for Linux and Solaris.