Qlogic 3200 Series User Manual - Host Port Configuration
6–Fibre Channel Noninteractive Commands
Host Port Configuration
SN0054667-00 G
6-3
Host Port Configuration
Use these options to show the information for one or all of the adapter ports in the
system. The -z option shows the combination of the commands listed in
. The commands are listed in alphabetical order.
.
Command Format
The command format for noninteractive mode is:
# qaucli -pr fc -(Cmd) (<hba instance> | <hba wwpn>)
(view | info)
Where:
You can combine the commands -o, -s, and -x with other options. However,
they must be at the beginning or at the end of the command line. Use these
commands as follows:
-o = Output the results to a file (see
). For example:
# qaucli -pr fc -l -o
Table 6-1. Options Shown by -z
CLI
Description
See User Guide Section
-c
Show adapter settings
“-c (Display HBA Parameters)” on page 6-8
-e
Configure boot device
“-e (Boot Devices Configuration)” on
-fg
View driver settings
-gs
Show adapter statistics
“-gs (Configure Parameters [FC Port Statis-
-i
Show adapter information
“-i (FC Adapter Information; FC VPD Informa-
-l
Show LUN list
“-l (FC Target/LUN Information)” on page 6-23
-m
Configure selective LUNs
“-m (Selective LUNs)” on page 6-25
-p
Configure target persistent
binding
“-p (Target Persistent Bindings)” on page 6-30
-t
Show target list
“-t (FC Target/LUN Information)” on page 6-37
hba instance = Adapter port instance (use the -g command to find)
hba wwpn = Adapter world wide port name