Qlogic 3200 Series User Manual - -Link
5–NIC Noninteractive Commands
-link
5-10
SN0054667-00 G
-link
To view the status of the physical link, including the port speed, issue the -link
command as follows:
> qaucli -pr nic -link [cna_port_inst]
For example:
> qaucli -pr nic -link 1
=== Physical Link Status for 1. CNA Port Index ===
Link Status : Up
Port Speed : 10 Gbps
-minidump
To dump a firmware core dump into a file for a specific cna_port_inst, issue
the -minidump command as follows:
> qaucli -pr nic -minidump <cna_port_inst> <minidump_file>
[force | noforce]
Where minidump_file specifies the name of the dump file, and force and
noforce specify how the core dump is created:
If force is specified, then a new core dump is created and dumped into
the specified file.
If
noforce is specified, then if a core dump is available, it is dumped into
the specified file.
-n
(Change Port Alias Name [NIC Configuration])
To change a port alias name, issue the -n command as follows:
> qaucli -pr nic -n [cna_port_inst] <config_name|config_alias>
<value> [<config_name|config_alias> <value>]
For this release of QConvergeConsole CLI, you can set the following properties:
Port_Alias
Port_Physical_MAC_Alias
Port_LLA_MAC_Alias
For example:
> qaucli -pr nic -n 1 Port_Alias jwm614
Port_Alias :
jwm614
NOTE
Linux does not support the Receive_Side_Scaling_Enable option.