Oce VarioPrint 5000 Operating Manual - 5.4 Refilling Paper

5.4 Refilling paper

A29246-X17-X-4-7680 / do501.fm

93

5.4 Refilling paper

When the fill level falls below a certain height in an input tray, the warning "Input tray X 

empty " is displayed on the operator panel. The input tray is lowered. All the associated 

display lamps flash while this is happening.

The input tray can be filled up during the print operation.

If several input trays are mapped, printing is continued without interruption and the paper is 

fed in from another input tray. 

The following description is valid for the input trays of the paper input, the cascade and the 

Interposer.

Proceed as follows:

1.

Once the input tray has reached the 

lower position, all associated indicator 

lamps will be on.

Now press the button for the 

corresponding input tray.

The input tray moves forward roughly 5 

cm.

Important

Pulling out the input tray too sharply and quickly can move the rest of the paper. This 

can cause paper feed problems later.

Pull out the input tray slowly.

2.

Take hold of the input tray by its 

recessed grip and pull out slowly until 

it stops.

Caution

Sharp paper edges can cut you.

Do not slide hands or fingers along the edges.