Oce VarioPrint 5000 Operating Manual - page 112

5.6.2 Configuring the input tray

102

A29246-X17-X-4-7680 / do501.fm

5.6.2 Configuring the input tray

The following description is valid for the input trays of the paper input, the cascade and the 

Interposer.

Proceed as follows:

1.

Press  button.

2.

Change the paper parameters for the individual input tray at the operator panel in the 

menu  . 

3.

Press the key for the selected input 

tray. 

The input tray is lowered. All display 

lamps flash while this is happening. 

Once the input tray has reached the 

lower position, all associated indicator 

lamps will be on.

4.

Press the key again. The input tray moves forward roughly 5 cm.

5.

Take hold of the input tray by its 

recessed grip and pull out slowly until 

it stops.

Caution

Sharp paper edges can cause cuts.

Do not slide hands or fingers along the edges.

6.

Remove the rest of the paper from the input tray.