Oce VarioPrint 5000 Operating Manual - page 34
2.6.2.4 Cleaning
24
A29246-X17-X-4-7680 / all203.fm
2.6.2.4 Cleaning
• Observe the instructions in section 6 Cleaning the printing system for cleaning the printing
system.
• For vacuuming, an industrial vacuum cleaner with grounded suction device, rubber noz-
zle and a filter insert for fine dustshould be used. When vacuuming large quantities of ton-
er spill (e. g. 1 bottle), an explosion-proof industrial vacuum cleaner must be used be-
cause there can be a high build-up of static charge when draining toner spill.
• Only use the recommended cleaning agents and equipment (see section Cleaning
agents and equipment, page 336).
2.6.2.5 Foreign bodies, noises
• Make sure that no objects (e. g. jewelry chains, paper clips, coins etc.) or liquids get into
the interior of the printing system, since this may result in electric shocks or short circuits.
Do not place objects on the printing system, and especially do not place containers with
fluid, such as drinking bottles, glasses, cups or vases on top of or in the immediate vicinity
of the printing system.
• Should the printing system emit any unusual or noticeable noises or smells, power down
the printing system and contact your service engineer.
2.6.2.6 Cooling, heat
• Do not obstruct the cooling ducts, since this may result in overheating or combustion
while the device is in operation.
• Make sure there is an adequate supply of fresh air and cooling air to the room in which
the printing system is located (see section Technical data, page 337).
• Do not obstruct the operating and service clearance areas in any way (see section 2.3
Operating and service clearance, page 17) .
• During operation, the fusing station in the printing system becomes very hot (up to
approx. 230° C / 446° F).
/ 446° F)You should therefore maintain the cooling times before beginning work in the
the Fuser Station area, and observe the corresponding instructions in this documentation
to avoid burns.