Oce VarioPrint 5000 Operating Manual - 6.1 Overview
6 Cleaning the printing system
A29246-X17-X-4-7680 / do601.fm
159
6 Cleaning the printing system
6.1 Overview
This section shows you the intervals for cleaning the different components.
Strictly observe the following safety information when cleaning.
Caution
Printing system could start unexpectedly if not in the "Stop" status.
Before cleaning, ensure that the printing system is in the "Stop" mode (press
button).
The components in the fuser station reach a surface temperature of approximately
230
o
C during operation. If you touch them, you may burn yourself.
Cleaning should be done preferably before you power on the printing system, while
the fuser station is still cold. Alternatively, allow the fuser station to cool down for
approximately half an hour before you start work.
There can be a high build-up of static charge when draining toner spill!
Always use an industrial vacuum cleaner with a grounded suction tube, rubber
nozzle and filter set for fine dust. For draining large quantities of toner spill (such as
a full bottle), the industrial vacuum cleaner must be explosion-proof.
There is a danger of slipping on toner or developer spill.
Clean up toner and developer spill immediately.
Important
Possibility of damage to the printing system when the wrong cleaning agents or
materials are used.
Use only the specified cleaning materials and cleaning units . (see section Cleaning
agents and equipment, page 336)
Spilt toner is soiled.
Re-using spilt toner causes printing problems.
Never use spilt toner for printing.