Oce VarioPrint 5000 Operating Manual - page 221
7.2.3 Replacing developer
A29246-X17-X-4-7680 / do701.fm
211
7.2.3 Replacing developer
600,000 A4 pages can be printed with the developer. After that,
a warning message
appears on the operator panel. If it is not replaced during the warning period of another
50,000 A4 pages, the printing system stops and an error message is displayed. The
developer must be replaced at this point.
The procedure for replacing the developer is the same for both print units; the only
difference is the position of the hook on which you place the developer bottle. The following
section shows the procedure for the upper print unit.
Draining developer
Caution
Strictly observe the following safety directives when replacing the developer:
• Do not allow developer to get into eyes. In the event of contact with eyes, rinse
eyes out with plenty of water and seek medical help.
• Avoid contact with the skin and wear gloves. In the event of contact with skin, wash
developer off with plenty of water.
• Do not inhale developer. Avoid accumulation of dust. If, after inhaling developer,
you experience symptoms such as nausea, headaches or dizziness, immediately
go out into the fresh air.
• Do not spill developer. There is a danger of slipping on developer spill. Clean up
developer spill immediately.
• Only use explosion-proof vacuum cleaners.
• use only permitted developer (see section Consumables, page 334).
• only refill with original, sealed developer bottles secured by an intact band,
• do not re-use developer that has already been used.
• Keep developer out of the reach of children and store it away from containers used
for food and drink.
• Keep used developer for collection by service or the contracted shipping company.
Proceed as follows:
1.
Make sure that you have at hand: a new full bottle of developer (pay attention to the
type), an empty developer bottle, and a vacuum cleaner.
2.
Press the
3.
Select the print unit concerned on the operator panel in the consumables>