Oce VarioPrint 5000 Operating Manual - page 312
8.3.2.5 Clearing a paper jam in the developer station
302
A29246-X17-X-4-7680 / do805.fm
8.3.2.5 Clearing a paper jam in the developer station
Proceed as follows:
1.
Open the center doors
Caution
If you pull out the developer station too sharply and quickly, you could pull it beyond
its stop point, causing it to drop to the floor. There is a danger of injury to you and of
damage to the developer station.
Always slide the developer station slowly and evenly to its stop point on the guide rail
(reference speed max. 0.5 m/s).
2.
Raise the handle and pull out the
developer station slowly and evenly.
Caution
Possibility of damage to the developer station.
The developer station must be kept free of foreign bodies. Metal objects (e.g. paper
clips) are a special danger as they are attracted by the rollers’ magnetic field.
Do not lean on the developer station while it is pulled out.
Possibility of damage to the photoconductor drum.
Never try to remove paper with hard objects (pliers, tweezers etc.).
Do not touch the photoconductor drum.
Sharp paper edges can cause cuts.
Do not slide hands or fingers along the edges.
Note
Possibility of soiling clothing on the developer station while it is pulled out.
Take care not to touch the developer station.
3.
Remove jammed paper.