Oce VarioPrint 5000 Operating Manual - page 280
7.3.10 Replace photoconductor drum
270
A29246-X17-X-4-7680 / do701.fm
7.3.10 Replace photoconductor drum
A defective photoconductor drum may be the cause of poor print quality. Prior to replacing
the photoconductor drum, check whether it may be the cause of the print image malfunction
(see section 8.4 Print image problems, page 323).
The procedure for replacing the photoconductor drum is the same for the upper and lower
print units. The following section shows the procedure for the upper print unit.
Remove the photoconductor drum
Caution
Strictly observe the following safety directives when replacing the photoconductor
drum:
• The photoconductor drum may only be replaced by operators after training or
instructions from service personnel.
• Skin ailments can result from touching the photoconductor drum. If you touch the
belt, wash skin thoroughly with soap and water. When replacing the
photoconductor drum, always wear the gloves provided.
• In the event that pieces of the photoconductor drum coating flake off, you must
collect all these pieces. Store old photoconductor drums with protective covers and
any flakes of coating in the original drum cartons, and keep ready for collection by
service or the contracted shipping company. Photoconductor drums and collected
flakes of coating require special disposal.
• Photoconductor drums may only be used only for the purpose for which they are
intended.
• If the photoconductor drum had only a short service life, the cause of the problem
must be identified in order to prevent further damage..
• Store new photoconductor drums in appropriate conditions:
– Do not store together with flammable substances
– Store in the closed original carton in a dry environment at 15 to 25
o
C .
– Keep out of the reach of children
Proceed as follows:
1.
Press the
2.
On the operator panel in the menu corotrons>, select the corotrons to be parked. Press 3. Select "Start motor for corotron parking".