Oce VarioPrint 5000 Operating Manual - page 230

7.2.4 Replacing the fuser oil container

220

A29246-X17-X-4-7680 / do701.fm

7.2.4 Replacing the fuser oil container

300,000 A4 pages can be printed with the fuser oil. After that,

a warning message appears 

on the operator panel. If it is not replaced during the warning period of another 50,000 A4 

pages, the printing system stops and an error message is displayed. The fuser oil container 

must be replaced at that point.

The procedure for replacing the fuser oil container is the same for both print units. The 

following section shows the procedure for the upper print unit.

Caution

Strictly observe the following safety directives when replacing the fuser oil container:

• Do not allow fuser oil to get into eyes. In the event of contact with eyes, rinse eyes 

out with plenty of water and seek medical help.

• Avoid contact with the skin. In the event of contact with the skin, wash fuser oil off 

with plenty of water.

• Do not spill fuser oil. There is a danger of slipping on spilled fuser oil. If you do spill 

fuser oil, immediately apply an agent such as diatomaceous earth (kieselguhr) to 

bind the fluid, and dispose of in a suitable manner.

• Only use fuser oil for the purpose for which it is intended.

• Keep fuser oil out of the reach of children and store it away from containers used 

for food and drink.

Proceed as follows:

1.

Press the button.

2.

Select the print unit concerned and "Fuser oil" on the operator panel in the 

   menu.

Press the  button.

3.

Open the center doors.

Important

Using the wrong fuser oil can cause malfunctions.

Only use fuser oil with the same order number (see order number on container and 

sticker on the printing system)

4.

Have a new fuser oil container ready, open it and spike open the seal at the marked 

spot (using a pencil or other pointed object).