Oce VarioPrint 5000 Operating Manual - page 189
6.3.6 Cleaning the cleaning station
A29246-X17-X-4-7680 / do601.fm
179
6.3.6 Cleaning the cleaning station
You must clean the upper and lower cleaning stations.
Proceed as follows:
1.
Open the center doors
Caution
If you pull out the cleaning station too sharply and quickly, you could pull it beyond
its stop point causing it to drop to the floor. There is a danger of injury to you and of
damage to the cleaning station.
Always slide the cleaning station slowly and evenly to its stop point on the guide rail
(reference speed max. 0.5 m/s).
2.
Lift up the handle and pull the cleaning
station slowly and evenly out of the
system.
Important
Possibility of damage to the sealing blade from the vacuum cleaner nozzle.
When vacuuming, do not touch the edge of the sealing blade.
3.
Remove any foreign matter from the U-
shaped guide bar.
Vacuum-clean the cleaning blade, U-
shaped guide bar and insulation felt.
Vacuum-clean around the sealing
blade and cleaning blade.