Oce VarioPrint 5000 Operating Manual - page 342
8.5 Substandard print quality in margin zones
332
A29246-X17-X-4-7680 / do805.fm
8.5 Substandard print quality in margin zones
In general, printing can be performed from margin to margin. However, due to the physical
properties of the paper – paper is affected by heat, damp, etc. – the print quality of areas of
color fill in the margin zone can be impaired, and the running properties of the paper may
also be sub-standard.
Therefore, in order to increase operating safety, we recommend that you construct your
applications so that no important print data is positioned in margin zones b when printing.
The portion of black in zone a (leading edge of sheets) should be kept as low as possible.
A short format is illustrated in the following diagram.
The values for the margin zones a and b are listed in the following table.
: secure print area without loss of data
Margin
zone
Print image
Width (mm) of margin zone with fuser station
-A1
-A2
with paper weight (g/m
2
)
60
70
80
60
70
80
a
Black area
8
8
5
6
6
5
25 % coverage
(application-
dependent)
6
6
3,5
4
3
1 ... 1,5
b
2
b
300 mm (11
.8 ")
a
b
Paper direction