Oce VarioPrint 5000 Operating Manual - page 136
5.9.2 Replacing fuser station
126
A29246-X17-X-4-7680 / do501.fm
5.9.2 Replacing fuser station
This section provides a detailed description of the work steps required to replace the fuser
station. Each station should be replaced with the aid of a trolley. Prepare the trolley before
removing the developer station, see section 5.9.1 Preparing the Trolley, page 121.
5.9.2.1 Removing fuser station >>> page 127
5.9.2.2 Replacing fuser station on the trolley >>> page 130
5.9.2.3 Installing fuser station >>> page 135
Caution
The components in the fuser station reach a surface temperature of approximately
230
o
C during operation. If you touch them, you may burn yourself.
Allow the fuser station to cool down approx. 1/2 hour before starting work.
The fuser station is heavy, approx. 19 kg (42 lb).
One person should only replace the fuser station if they can handle the weight by
themselves.
Important
When replacing the fuser station, please note
Always place the fuser station into the fireproof tray.