Oce VarioPrint 5000 Operating Manual - page 306
8.3.2.3 Clearing a paper jam in the flaps
296
A29246-X17-X-4-7680 / do805.fm
• Jammed large formats can also be located in adjacent stations. Then it is necessary to
remove both stations and only then remove the paper from both stations.
• Check the removed sheets for torn corners or sections. If sections are missing, they must
also be removed from the paper path, since otherwise another paper jam is likely to occur
when the printer is started.
8.3.2.3 Clearing a paper jam in the flaps
The operator panel displays the error message ".. Paper jam" informs you which flaps you
must open to clear the paper jam. The numbers are printed on the green release flap knobs.
When working with the flap groups in the following table, the flaps must be opened in the
given sequence. The flaps must be closed in reverse order.
There are no special points to note for the other flaps and flap groups.
Flap group
Open in this order
8
8.1 - 8.2
10
10.1 - 10.2
11
11.1 - 11.2
49
49.1 - 49.2 - 49.3 - 49.4
51
51.1 - 51.2
64
64.1 - 64.2
Proceed as follows:
1.
Open the door in front of the jam area.
2.
Pull the release knob of the flap specified in the error message and in the operator
panel and affix in position in the top notch. The release knob must be flush with the
plate.
3.
Maneuver the jammed paper into a better position for removal by turning the
unnumbered green knobs.
Caution
Sharp paper edges can cut you.
Do not slide hands or fingers along the edges.
4.
Remove jammed paper.
5.
Close all flaps again. Affix the release knobs in the notches indicated in blue. The
release knobs must be flush with the plate.