Oce VarioPrint 5000 Operating Manual - page 331
8.3.4.2 Setting for Predecurler
A29246-X17-X-4-7680 / do805.fm
321
8.3.4.2 Setting for Predecurler
The following table lists the optimal Predecurler settings for the determined sheet curl.
8.
Click on the
9.
In the "Curl in input tray" field, set the slide control to the corresponding value from
table 8.3.4.2 Setting for Predecurler, page 321.
10. Click on
11. If you had to interrupt a print job to correct a disruption, re-start the print job by
clicking on the
Note
• The settings in the following table are standard values. The settings may deviate
in some cases from the standard values due to different paper properties.
Example:
Paper in the input tray with a low curl value may, nevertheless, require a higher
Predecurl value due to poor physical paper properties.
• The way the sheet curl is depicted in the table does not indicate the degree of the
curl.
Print mode
Papercurl
Curl value as
per
measurement
sheet according
to ISO 14968
Setting for the
Predecurler at
the lower print
unit
Automatically
assigned value
for the
Predecurler of
the upper print
unit
Monochrome Automode
Duplex
CustomTone Automode
2.75 to 5
Max
Max
Max
Max
Max
Max
Monochrome Automode
Duplex
CustomTone Automode
1.75 to 2.5
2
2
2
2
2
2
Proceed as follows: