Oce VarioPrint 5000 Operating Manual - page 180
6.3.4 Cleaning the transfer station
170
A29246-X17-X-4-7680 / do601.fm
6.3.4 Cleaning the transfer station
You must clean the upper and lower transfer station.
Proceed as follows:
Caution
If you pull out the transfer station too sharply and quickly, you could pull it beyond its
stop point, causing it to drop to the floor. There is a danger of injury to you and of
damage to the transfer station.
Always slide the transfer station slowly and evenly to its stop point on the guide rail
(reference speed max. 0.5 m/s).
1.
Rotate the knob to the left until it
engages.
Take the transfer station by its handle
and pull it towards you slowly and
evenly.
2.
Release transport belt unit and raise
up until it engages.
Important
The transport belt, cleaning blade (transfer), sealing blade and the other cover
elements may be damaged by the vacuum cleaner nozzle.
Do not touch these parts when vacuuming.