Oce VarioPrint 5000 Operating Manual - page 252
7.3.4 Replacing the oiling roller
242
A29246-X17-X-4-7680 / do701.fm
Removing the oiling roller
Proceed as follows:
1.
Press the
2.
Select the print unit concerned and "Oiling roller" on the operator panel in the
Press the
3.
Open the center doors.
Caution
If you pull out the fuser station too sharply and quickly, you could pull it beyond its
stop point causing it to drop to the floor. There is danger of injury to you and of
damage to the fuser station.
Always slide the fuser station slowly and evenly to its stop point on the guide rail
(reference speed max. 0.5 m/s).
4.
Rotate the knob to the left until it
engages.
Take hold of the fuser station and pull
it towards you slowly and evenly.
Caution
The components in the fuser station reach a surface temperature of approximately
230
o
C during operation. If you touch them, you may burn yourself.
Before beginning work, open the fuser station and allow the printing system to cool
for approx.1/2 hour.