Oce VarioPrint 5000 Operating Manual - page 263
7.3.6 Replacing the transport belt
A29246-X17-X-4-7680 / do701.fm
253
7.3.6 Replacing the transport belt
2,000,000 A4 pages can be printed with the transport belt. After that,
a warning message
appears on the operator panel. If it is not replaced during the warning period of another
100,000 A4 pages, the printing system stops and an error message is displayed. The
transport belt has to be replaced at this point.
The procedure for replacing the transport belt is the same for the upper and lower transfer
stations. The following section shows the procedure for the upper cleaning station.
Removing the transport belt
Proceed as follows:
1.
Press the
2.
Select the print unit concerned and "Transport belt" on the operator panel in the
Press the
3.
Open the center doors.
Caution
If you pull out the transfer station too sharply and quickly, you could pull it beyond its
stop point, causing it to drop to the floor. There is a danger of injury to you and of
damage to the transfer station.
Always slide the transfer station slowly and evenly to its stop point on the guide rail
(reference speed max. 0.5 m/s).
4.
Rotate the knob to the left until it
engages.
Take the transfer station by its handle
and pull it towards you slowly and
evenly.