Oce VarioPrint 5000 Operating Manual - page 137
5.9.2.1 Removing fuser station
A29246-X17-X-4-7680 / do501.fm
127
5.9.2.1 Removing fuser station
Proceed as follows:
1.
Press
2.
Open the center doors.
Caution
If you pull out the fuser station too sharply and quickly, you could pull it beyond its
stop point causing it to drop to the floor. There is danger of injury to you and of
damage to the fuser station.
Always slide the fuser station slowly and evenly to its stop point on the guide rail
(reference speed max. 0.5 m/s).
3.
Rotate the knob to the left until it
engages.
Take hold of the fuser station and pull
it towards you slowly and evenly.
4.
Release the trolley brake. To do this,
press the upper part of the trolley
brake on the two rear wheels.
5.
Empty trolley using the fireproof tray in front of the fuser station.