Oce VarioPrint 5000 Operating Manual - page 327
8.3.3.2 Optimizing decurler settings
A29246-X17-X-4-7680 / do805.fm
317
8.3.3.2 Optimizing decurler settings
The following table shows the optimal decurler settings for the curl based on the test print.
• The way the sheet curl is depicted in the table does not indicate the degree of the curl.
•
: This arrow indicates that the setting needs to be changed gradually. If an arrow is
not listed in the row, then the decurler setting does not have to be changed.
• Note on the column "Optimize lower print unit decurler":
For the Duplex, CustomTone Simplex and CustomTone Duplex print modes, the values
of the decurler for the lower print unit are only changed if there is a paper jam in the upper
photoconductor drum.
mode
Actual direction
of sheet curl
for the menu
setting
down> for
paper output
Optimize
decurler on
lower print unit
Optimize decurler on
upper print
unit
Set direction of
sheet curl
for the menu
setting
down> for paper
output
Replace setting gradually from ..
to
..
Fast Simplex
(Auto Mode)
0
-1
-2
0
+1
+2
0
0
Duplex
(Auto Mode)
-1
-2,
see
note above
+1
0
-1
-2
+1
CustomTone
Simplex
+1
+2, see
note above
0
-1
-2
0
CustomTone
Duplex
+1
+2, see
note above
0
0
+1
+2