Oce VarioPrint 5000 Operating Manual - page 184
6.3.5 Cleaning the fuser station daily
174
A29246-X17-X-4-7680 / do601.fm
6.3.5 Cleaning the fuser station daily
You must clean the upper and lower fuser stations.
The printing system may contain either the fuser station -A1 or -A2. The variant is identified
by a sticker on the fuser station.
Tip
Differences between the daily and weekly cleaning operations of the fuser station.
Clean the fuser station daily according to 6.3.5 Cleaning the fuser station daily >>>
page 174 and weekly according to 6.4.3 Cleaning the fuser station weekly >>> page
186.
Caution
The components in the fuser station reach a surface temperature of approximately
230
o
C during operation. If you touch them, you may burn yourself.
Cleaning should be done preferably before you power on the printing system, while
the fuser station is still cold. Alternatively, allow the fuser station to cool down for
approximately half an hour before you start work.
Proceed as follows:
Caution
If you pull out the fuser station too sharply and quickly, you could pull it beyond its
stop point causing it to drop to the floor. There is danger of injury to you and of
damage to the fuser station.
Always slide the fuser station slowly and evenly to its stop point on the guide rail
(reference speed max. 0.5 m/s).