Oce VarioPrint 5000 Operating Manual - page 87
4.3.4.1 Calling up and operating the Job wizard.
A29246-X17-X-4-7680 / do405.fm
77
Apply settings
The settings for the printing system can be applied at the end of every procedure:
4.3.4.1 Calling up and operating the Job wizard.
With the Job wizard, you can configure the printing system in a predefined order of steps.
The following sections explain individual menus of the Job wizard:
• Load setup >>> page 78
• Save settings in the setup >>> page 78
• Stop wizard (pause) >>> page 76
• Continuing the procedure >>> page 76
Proceed as follows:
1.
Press
. Only the settings for the currently displayed dialog will be
reset. The previous and subsequent dialogs will not be changed.
Proceed as follows:
1.
Press .
Proceed as follows:
1.
On the operator panel, select the
2.
Select the option "Job wizard" in the dialog.
3.
Press
.
The first dialog in the Job wizard is the setup dialog, (see section Load setup, page
78)
4.
Click on
to call up the next dialog.