Oce VarioPrint 5000 Operating Manual - page 176
6.3.2 Cleaning the developer station
166
A29246-X17-X-4-7680 / do601.fm
6.3.2 Cleaning the developer station
You must clean the upper and lower developer stations.
Proceed as follows:
1.
Open the center doors
Caution
If you pull out the developer station too sharply and quickly, you could pull it beyond
its stop point, causing it to drop to the floor. There is a danger of injury to you and of
damage to the developer station.
Always slide the developer station slowly and evenly to its stop point on the guide rail
(reference speed max. 0.5 m/s).
2.
Raise the handle and pull out the
developer station slowly and evenly.
Important
You must not vacuum around the developer roller because you could vacuum up
developer mix.
When performing the following cleaning, only vacuum the specified parts.