Oce VarioPrint 5000 Operating Manual - 7.3 Replace Expendables
7.3 Replace expendables
224
A29246-X17-X-4-7680 / do701.fm
7.3 Replace expendables
The following sections detail the steps for replacing consumables and expendables. You
only need the tools provided to replace the sealing blade in the cleaning station. Tools are
not required for any other procedures.
A warning on the operator panel indicates when the expendables should be replaced. If the
consumables are not replaced before a particular number of pages are printed, the printing
system stops and displays an error message. The relevant expendable must be changed
at that point.
Caution
Possibility of injury while refilling and replacing expendables.
Always observe the safety directives in the relevant sections and on the packaging
of the expendable.
Expendable
Operator panel message
See section
Cleaning blade (cleaning) in
the lower cleaning station
Cleaning blade (cleaning) in
the upper cleaning station
Replace the cleaning blade
(cleaning) in the lower
cleaning station
Replace the cleaning blade
(cleaning) in the upper
cleaning station
7.3.1 Replacing or
turning the cleaning
blade (cleaning) >>>
page 227
Cleaning blade (cleaning) in
the lower cleaning station
Cleaning blade (cleaning) in
the upper cleaning station
Turn the cleaning blade
(cleaning) in the lower
cleaning station
Turn the cleaning blade
(cleaning) in the upper
cleaning station
7.3.1 Replacing or
turning the cleaning
blade (cleaning) >>>
page 227
Sealing blade in the lower
cleaning station
Sealing blade in the upper
cleaning station
Replacing sealing blade in
the lower cleaning station
Replacing sealing blade in
the upper cleaning station
7.3.2 Replacing the
sealing blade (cleaning)
>>> page 231
Oiling roller in the lower fuser
station
Oiling roller in the upper fuser
station
Change lower oiling roller
Change upper oiling roller
7.3.4 Replacing the
oiling roller >>> page
241