Oce VarioPrint 5000 Operating Manual - page 268
7.3.7 Turning or replacing the cleaning blade (transfer)
258
A29246-X17-X-4-7680 / do701.fm
7.3.7 Turning or replacing the cleaning blade (transfer)
600,000 A4 pages can be printed with each edge of the cleaning blade (transfer), I.e. a total
of 2,400,400 A4 pages per blade (transfer). A warning message is displayed after every
600,000 A4 pages. If the blade (transfer) is not turned or replaced during the warning period
of another 50,000 A4 pages, the printing system stops and an error message is displayed.
The blade (transfer) must now be replaced or turned.
The four edges of the cleaning blade (transfer) are numbered "1", "2", "3" and "4". These
are used one after the other.
The procedure for replacing or turning the cleaning blade (transfer) is the same for the
upper and lower transfer stations. The following section shows the procedure for the upper
transfer station.
Remove cleaning blade (transfer)
Caution
Possibility of damage to the cleaning blade edges.
If the cleaning blade (transfer) is to be replaced or turned, ensure that you do not
damage the edge during the following removal and installation .
Proceed as follows:
1.
Press the
2.
Select the print unit concerned and "Cleaning blade (transfer)" on the operator panel
in the
Press the
3.
Open the center doors.
Caution
If you pull out the transfer station too sharply and quickly, you could pull it beyond its
stop point, causing it to drop to the floor. There is a danger of injury to you and of
damage to the transfer station.
Always slide the transfer station slowly and evenly to its stop point on the guide rail
(reference speed max. 0.5 m/s).