Oce VarioPrint 5000 Operating Manual - page 326
8.3.3.1 Print test pages
316
A29246-X17-X-4-7680 / do805.fm
12.
Press the key on the output tray. The
stacker platform is lowered.
Caution
If you pull out the output tray too sharply and quickly, you could pull it beyond its
stoppoint, causing it to drop to the floor. There is a danger of injury to you and of
damage to the output tray.
Always slide the output tray slowly and evenly to its stop point on the guide rail
(reference speed max. 0.5 m/s).
13.
When the stacker platform has
stopped moving pull up the handle to
release the output tray and pull the tray
slowly and evenly out of the printer.
14. Remove one printed sheet from the output tray and determine the direction of the
curl. If it does not correspond to the reference sheet curl in the following table, you
must adjust the decurler setting.
15. Slide the output tray back into the printer. The catches should engage noticeably.
Proceed as follows: