Oce VarioPrint 5000 Operating Manual - page 194
6.4.2 Cleaning the transfer discharge stick
184
A29246-X17-X-4-7680 / do601.fm
6.4.2 Cleaning the transfer discharge stick
You must clean the upper and lower transfer discharge stick.
Proceed as follows:
Caution
If you pull out the transfer station too sharply and quickly, you could pull it beyond its
stop point, causing it to drop to the floor. There is a danger of injury to you and of
damage to the transfer station.
Always slide the transfer station slowly and evenly to its stop point on the guide rail
(reference speed max. 0.5 m/s).
1.
Rotate the knob to the left until it
engages.
Take the transfer station by its handle
and pull it towards you slowly and
evenly.
Caution
If you pull out the cleaning station too sharply and quickly, you could pull it beyond
its stop point causing it to drop to the floor. There is a danger of injury to you and of
damage to the cleaning station.
Always slide the cleaning station slowly and evenly to its stop point on the guide rail
(reference speed max. 0.5 m/s).
2.
Lift up the handle and pull the cleaning
station slowly and evenly out of the
system.