Oce VarioPrint 5000 Operating Manual - page 257
7.3.5 Replacing the cleaning kit
A29246-X17-X-4-7680 / do701.fm
247
7.3.5 Replacing the cleaning kit
500,000 A4 pages can be printed with the cleaning kit. After that,
a warning message
appears on the operator panel. If it is not replaced during the warning period of another
50,000 A4 pages, the printing system stops and an error message is displayed. The
cleaning kit must be replaced at that point.
The procedure for replacing the cleaning kit is the same for the upper and lower fuser
stations. The following section shows the procedure for the upper fuser station.
Remove the cleaning set
Proceed as follows:
1.
Press the
2.
Select the print unit concerned and "Cleaning kit" on the operator panel in the
Press the
3.
Open the center doors.
Caution
If you pull out the fuser station too sharply and quickly, you could pull it beyond its
stop point causing it to drop to the floor. There is danger of injury to you and of
damage to the fuser station.
Always slide the fuser station slowly and evenly to its stop point on the guide rail
(reference speed max. 0.5 m/s).