Oce VarioPrint 5000 Operating Manual - 7.2 Replacing Consumables
7.2 Replacing consumables
198
A29246-X17-X-4-7680 / do701.fm
7.2 Replacing consumables
The following sections detail the steps for replacing consumables and expendables.
A warning on the operator panel indicates when the consumables should be refilled or
replaced. If the consumables are not replaced before a particular number of pages are
printed, the printing system stops and displays an error message. The relevant consumable
or expendable must be replaced at that point.
Caution
Possibility of injury while refilling and replacing consumables.
Always observe the safety directives in the relevant sections and on the packaging
of the consumable.
Consumable
Operator panel message
See section
Toner in the lower print unit
Toner in the upper print unit
Lower toner empty
Toner in upper print unit
empty
7.2.1 Refilling toner
>>> page 199
Waste toner box in lower print
unit
Waste toner box in upper print
unit
Lower waste toner box full
Upper waste toner box full
7.2.2 Replacing waste
toner box (rear) and
waste toner box
(transfer) >>> page
205
Waste toner box (transfer) full in
lower print unit
Waste toner box (transfer) full in
upper print unit
Lower toner drop-off tray full
Upper toner drop-off tray full
7.2.2 Replacing waste
toner box (rear) and
waste toner box
(transfer) >>> page
205
Developer in the lower
developer station
Developer in the upper
developer station
Replace lower developer
Change developer in upper
print unit
7.2.3 Replacing
developer >>> page
211
Fuser oil container in lower fuser
station
Fuser oil container in upper fuser
station
Change lower fusing oil
container
Change upper fusing oil
container
7.2.4 Replacing the
fuser oil container >>>
page 220