NEC Univerge SV8100 Programming Manual - page 179
UNIVERGE SV8100
Issue 1.0
Programming Manual
2 - 139
06
Pause at 1st Digit after Line Seize in
Manual Dial Mode
0 = No Pause (No)
1 = Pause (Yes)
1
21-01-06
07
DP to DTMF Conversion Options
Determine how a user can convert a
Dial Pulse (DP) call to a DTMF call. For
each trunk, set the type of DP to DTMF
conversion required. There are three
conversion options: Automatic (0),
Automatic and Manual (1), or Manual
(2).
Automatic:
DP to DTMF conversion occurs
automatically if the extension user
waits more than 10 seconds before
dialing the next digit.
Automatic and Manual:
DP to DTMF conversion occurs
automatically if the extension user
waits more than 10 seconds before
dialing the next digit. In addition, the
user can dial
#
to switch a DP trunk to
DTMF dialing.
Manual:
Users can dial
#
to switch a DP trunk
to DTMF dialing.
0 = Automatic
1 = Automatic and
Manual
2 = Manual
2
21-01-03
08
Answering Condition
0 = Polarity
Reversing
(Polarity)
1 =
Polarity
Reversing or
Timer (Int Digit)
1
21-01-03
09
Busy Tone Detection
0 = Disable (No)
1 = Enable (Yes)
0
10
Caller ID
Enable or disable a trunk to receive
Caller ID information.
0 = No
1 = Yes
0
11
Next Trunk in Rotary if No Dial Tone
Use this option to enable/disable the
system ability to skip over a trunk if dial
tone is not detected. This option
pertains to calls placed using Speed
Dial, ARS, Last Number Redial or
Save Number dialed. It does not
pertain to line key or Direct Trunk
Access calls.
0 = Disable (No)
1 = Enable (Yes)
0
12
Detect Network Disconnect Signal
0 = Disable (No)
1 = Enable (Yes)
1
Item
No.
Item
Input Data
Default
Related
Program