NEC Univerge SV8100 Programming Manual - page 61
UNIVERGE SV8100
Issue 1.0
Programming Manual
2 - 21
Description
Use Program 10-09 : DTMF and Dial Tone Circuit Setup to allocate the circuits on
the CD-CP00-US for either DTMF receiving or dial tone detection. The CD-CP00-US
has 32 circuits initially, and an addition 64 circuits are added when a PZ-BS10 is
installed. These are used as follows:
Extension
DTMF receiver for single line telephone
Trunk
DTMF receiver for analog trunks, dial tone & busy tone detection
for analog trunks
Conditions
None
Feature Cross Reference
Caller ID
Central Office Calls, Placing
Direct Inward Dialing (DID)
Direct Inward System Access (DISA)
Tie Lines
Program 10 : System Configuration Setup
10-09 : DTMF and Dial Tone Circuit Setup
Level:
IN
Input Data
Circuit/Resource Number
01~160
Item
No.
Input Data
Default Setting
01
0 = Common Use
1 = Extension Only
2 = Trunk Only
Circuit/Resource 01~08 = 1 (Extensions)
Circuit/Resource 09~32 = 2 (Trunks)
(Circuit/Resource 33~96 are not used.)
Circuit/Resource 97~160 = 0 (Common)
When PZ-BS10 is installed, 97~160 are
available.