NEC Univerge SV8100 Programming Manual - 90-05 : Slot Control
Issue 1.0
UNIVERGE SV8100
2 - 700
Program 90 : Maintenance Program
Description
(This program is available only via telephone programming and not through PC
Programming).
Use Program 90-05 : Slot Control to reset or delete (uninstall) blades (slots 1~24).
Delete allows you to completely uninstall the blade.
You should do this if you want to
remove a blade
and plug it into a different slot and still retain the port assignments. If
a different type of interface blade is being installed in a slot previously used (e.g.,
changing from a LCA
to an DLCA blade), the slot should be deleted (option 1) first
before installing the new interface blade.
Reset allows you to send a reset code.
Conditions
When you delete or reset a blade, you must first remove it from its slot then run
Program 90-05. When reusing the slot for another blade, you must plug the blade
in or reset the system before the system can use the slot again.
When you delete or reset a blade, all related programming in Program 10-03-01 is
set back to default.
Feature Cross Reference
None
Program 90 : Maintenance Program
90-05 : Slot Control
Level:
IN
Input Data
Menu Number
1 = Delete
2 = Reset
3 = Set Busy Out
4 = Reset Busy Out
Item
No.
Item
Input Data
01
Slot Control
Slot Number (1~24)