NEC Univerge SV8100 Programming Manual - page 246
Issue 1.0
UNIVERGE SV8100
2 - 206
Program 20 : System Option Setup
Description
Use Program 20-03 : System Options for Single Line Telephones to set up
various options for single line telephones.
Program 20 : System Option Setup
20-03 : System Options for Single Line Telephones
Level:
IN
Input Data
Item
No.
Item
Input Data
Default
Related
Program
01
SLT Call Waiting Answer Mode
For a busy single line (500/2500 type)
telephone, set the mode used to answer a
camped-on trunk call.
0 = Hookflash
(Hooking)
1 = Hookflash +
Service
Code 654
0
11-12-47
02
Ignore Received DP Dial on DTMF SLT Port
Use this option to define whether the system
should receive dial pulse and DTMF signals
(0) or ignore dial pulse and only accept DTMF
signals (1).
0 = Do Not
Ignore (No)
1 = Ignore (Yes)
0
15-03-01
03
SLT DTMF Dial to Trunk Lines
Type 0: The system keeps the digits
dialed by the single line telephone on a
trunk in a buffer. After all the digits are
received, the system sends all the digits
to the trunk. If the time space between
digits is longer than the time in Item 4, the
system considers all digits received.
Type 1: The system passes the received
digits from the single line telephone to the
trunk immediately. If the single line
telephone has a Last Number Dial key
without a pause, this key may not be able
to use the Last Number Dial key with the
Type 1 setting.
When using a third-party external paging
device, set this option to 1. In addition, set
Program 20-03-04 to 1. These programs must
be set for Wireless – DECT users to be able
to break dial tone on an analog trunk that is
used for paging.
0 = Receive all
dialed data,
before
sending (All)
1 = Direct
through out
(Direct)
0
20-03-04