NEC Univerge SV8100 Programming Manual - page 401
UNIVERGE SV8100
Issue 1.0
Programming Manual
2 - 361
Description
Use Program 30-03 : DSS Console Key Assignments to customize the key
assignments for 60-button DSS Consoles. A DSS Console key can have any function
with up to four digits (e.g., extension number or Service Code).
To prevent lamp problems when reassigning DSS Console keys, clearing an
extension programmed key before reassigning it is recommended [Enter key to be
cleared + 00 or 00 (If using WebPro or PC Programming, delete the key
assignments and upload the change to the system before proceeding.)] Without
clearing an extension key first, the DSS Console may not show the correct lamp
display, although the DSS function works correctly.
If you are programming the system from the extension to which the DSS Console is
connected, either by phone or using the WebPro or PC Program, you may need to
unplug the DSS and plug it back in to reset the console lamping.
Input Data
Program 30 : DSS/DLS Console Setup
30-03 : DSS Console Key Assignment
Level:
SA
Index 1
DSS Console Number
01~32
Index 2
Item
No.
Key Number
Function Number
Additional Data
01
001~114
0~99 (General Functional Level)
97 = Door Box Access key
(additional data: 1~8 Door Box No.)
00 ~ 99 (Appearance Functional
Level)
Refer to
Function Number
List
on the following pages.