NEC Univerge SV8100 Programming Manual - Program 51 : Netlink Service
UNIVERGE SV8100
Issue 1.0
Programming Manual
2 - 581
Description
Use Program 51-16: NetLink System Data Replication Mode Setting to set the
system data replication between the Primary and Secondary systems.
Program 51 : NetLink Service
51-16 : NetLink System Data Replication Mode Setting
Level:
IN
Input Data
Item
No.
Item
Input Data
Default
01
System Data Replication Mode
Sets the synchronous mode of the system data.
When set to 1 (Setting Time Mode), the systems
are synchronized at the time set in Item 02
below.
When set to 2 (Interval Mode), the systems are
synchronized at regular time intervals set in Item
03 below.
0 = Disable
1 = Setting Time Mode
2 = Interval Mode
0
02
System Data Replication Time Setting
Sets the time of day that both systems
synchronize database (when Item 01 is set to 1.)
0000~2359
0200
03
System Data Replication Interval Setting
Sets the time interval that both systems
synchronize database (when Item 01 is set to 2).
15~1440 (minutes)
30 (min)
04
Replication Time Stamp
Show next replication time. (Read-Only)
Month: 0~12
–
Day: 0~31
–
Hour: 00~23
–
Minute: 00~59
–
05
System Data Replication Wait Time
This sets the wait time until replication starts
when NetLink is created.
1~86400 (seconds)
180 sec
06
System Data Replication Interval
This program sets an interval time to start
replication to the next node after replication to
one node is completed.
0~86400 (seconds)
1 sec