NEC Univerge SV8100 Programming Manual - 44-05 : Ars/f-Route Table
UNIVERGE SV8100
Issue 1.0
Programming Manual
2 - 471
Description
Use
Program 44-05 : ARS/F-Route Table
to set the ARS/F-Route table. There are four
kinds of order. If the higher priority trunk groups are busy, the next order group is
used. If a lower priority route is selected, the caller may be notified with a beep tone.
Program 44 : ARS/F-Route Setup
44-05 : ARS/F-Route Table
Level:
IN
Input Data
ARS/F-Route Table Number
1~500
Priority Number
1~4
Item
No.
Item
Input Data
Default
01
Trunk Group Number
Select the trunk group number to be used for the
outgoing ARS call.
0~100, 255
0 = No Setting
255 = Extension Call
0
02
Delete Digits
Enter the number of digits to be deleted from the
dialed number.
0~255
(255 = Delete All)
0
03
Additional Dial Number Table
Enter the table number (defined in Program 44-06)
for additional digits to be dialed.
0~1000
0
04
Beep Tone
Select whether or not a beep is heard if a lower
priority trunk group is used to dial out.
0 = Off
1 = On
0
05
Gain Table Number for Internal Calls
Select the gain table number to be used for the
internal call (defined in Program 44-07).
0~500
0 = No Setting
0
06
Gain Table Number for Tandem Connections
Select the gain table number to be used for the
tandem call (defined in Program 44-07).
0~500
0 = No Setting
0
07
ARS Class of Service
Select the ARS Class of Service to be used for the
table. An extension ARS COS is determined in
Program 26-04-01.
0~16
0