NEC Univerge SV8100 Programming Manual - Program 47 : Inmail
UNIVERGE SV8100
Issue 1.0
Programming Manual
2 - 495
Description
Use
47-02 :
VM8000 InMail
Station Mailbox Options
to set up a station/extension
mailbox. Station mailboxes are automatically assigned as Subscriber Mailboxes.
Normally, VM8000 InMail Station Mailbox numbers 1~26 should correspond to
extensions 101~126.
Station Mailboxes are one of three mailbox categories: Station, Routing, or
Master. You can also set up Master Mailboxes as Subscriber Mailboxes.
Program 47 : InMail
47-02 : VM8000 InMail Station Mailbox Options
Level:
IN
Input Data
Station Mailbox Number
1~512
Input Data
Item
No.
Item
Input Data
Default
01
Mailbox Type
Use this option to enable or disable the mailbox. An
extension mailbox is not accessible when it is
disabled (even though its stored messages and
configuration are retained in memory.) If disabled, a
user pressing Message initiates a remote logon and
is asked to enter their mailbox number. A voice
prompt then announces: “That mailbox does not
exist.”
To make programming easier, consider associating
a mailbox number with a station port. For example,
mailbox 1 could correspond to port 1, which in turn
corresponds to extension 101.
0 = None
1 = Personal
2 = Group
1
02
Mailbox Number
Use this option to select the extension number
associated with the mailbox you are programming.
Normally, mailbox 1 should use Mailbox Number
101, mailbox 2 should use Mailbox Number 102, etc.
To make programming easier, consider associating
a mailbox number with a station port. For example,
mailbox 1 could correspond to port 1, which in turn
corresponds to extension 101.
Digits (8 maximum,
using 0~9)
Mailbox 1 = 101
Mailboxes 2~64 =
102~164
Mailboxes 65~512
= No entry