NEC Univerge SV8100 Programming Manual - page 204
Issue 1.0
UNIVERGE SV8100
2 - 164
Program 15 : Extension, Basic Setup
06
Extension Polarity Reverse
Not Used in U.S. --
Do Not Change Default Entry as DTMF issues
may arise with voice mail.
0 = Disable
(Off)
1 = Enable
(On)
0
07
Enabled On-Hook When Holding (SLT)
0 = No
1 = Yes
1
11-12-45
08
Answer On-Hook when Holding (SLT)
0 = Disable
(No)
1 = Yes
(Enable)
1
11-12-46
09
Caller ID Function - For External Module
Enable (1) or disable (0) the Caller ID FSK signal
for an external Caller ID module or a 3rd party
vendor telephone with Caller ID display.
Important:
If voice mail is used, this setting must be
disabled for the system integration codes to be
correct.
With a 2500 set (no Caller ID) installed, this
must be set to 0 for incoming callers to have a
talk path.
0 = Disable
(Off)
1 = Enable
(On)
0
10
Caller ID Name
Determine if an extension user telephone should
display the Caller ID name.
0 = Disable
1 = Enable
1
15-03-09
11
Caller ID Type
Determine whether the Caller ID type is FSK or
DTMF.
0 = FSK
1 = DTMF
0
14
Forwarded Caller ID Display Mode
Determine what the display shows when a
multiline terminal receives a forwarded outside
call.
0 = Calling
Extension
Number
(Calling)
1 = External
Caller ID
(Forward)
0
15
Disconnect without dial after hooking hold
Determine whether or not to disconnect a held
call when on-hook without any dialing after
hooking-hold.
0 = Normal
1 = Disc.
0
16
Special DTMF Protocol Send
Determine whether or not to send the extension
number of the phone forwarded to the extension
when PRG 15-03-04 is set to Special (1) and not
in the VM group.
0 = No
1 = Yes
0
Item
No
Item
Input Data
Default
Related
Program