NEC Univerge SV8100 Programming Manual - page 666
Issue 1.0
UNIVERGE SV8100
2 - 626
Program 81 : Basic Hardware Setup for Trunk
Description
Use Program 81-11 : Tie Line Initial Setup to define the various initial data for DID/
TLI/DTI packages.
Program 81 : Basic Hardware Setup for Trunk
81-11 : Tie Line Initial Setup
Level:
IN
Input Data
Trunk No.
1~ 200
Item
No.
Item
Input Data
Default
01
DP Interdigit Time Selection
The DP Interdigit Time is the minimum
pause time between dial pulses. Use this
Program to select either Pattern A or
pattern B.
0 = Pattern A
(Pattern A: 10pps – 650ms,
20pps – 500ms)
1 = Pattern B
(Pattern B: 10pps – 800ms,
20pps – 800ms)
1
02
Prepause Time Selection
Specifies the loop open time for a hookflash
signal sent to the Tie Line when the Recall
key on a multiline terminal is pressed. A
Single Line Telephone (SLT) generates a
hookflash to the Tie Line when a SLT
hookflash is assigned.
1~4
(1~4 = 0.5~2.0 seconds)
(5~15 = 3.0~13 seconds)
(0 = No Setting)
0
(No Setting)
03
Tie Line Answer Detect Time Selection
Specifies the time before a UNIVERGE
SV8100 system answer (Off-Hook) is
recognized as an answer.
0~15
(130ms~1950ms)
(0 = No Setting)
4
(520ms)
04
Tie Line Release Detect Time Selection
Specifies the circuit disconnect detected on
the Tie Line on the distant system side is
recognized as Tie Line.
0~15
(130ms~1950ms)
(0 = No Setting)
4
(520ms)